Runco Quantum Color Q-750d Series, Руководство по установке и эксплуатации

Страница: 58 / 134

Installation
42 Q-750d Ultra Series Installation/Operation Manual
PRE
L
IMINAR
Y
Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-21. For more information about configuring and using this
connection, refer to
Network on page 76.
Figure 3-21. Ethernet Network Connection to DHD Controller
Connecting to AC Power Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the Q-750d Ultra (AC 100V ~ 240V). Then, connect the other
end to your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
Auto S cope Len s Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
To Accessory Box
IR
Display Control
HDMI 3
HDMI 4 Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
To Accessory Box
IR
Display Control
HDMI 3
HDMI 4
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
1 8
to Ethernet
Hub, Router
or Gateway
1 Tran s mit Data +
2 Tran s mit Data -
3 Receive Data +
6 Receive Data -
➤