Operation
Q-750d Ultra Series Installation/Operation Manual
81
PRE
L
IMINAR
Y
S
ync Thre
s
hold:
Select Sync Threshold to adjust the threshold at which negative pulses
on the component video green/luma channel are interpreted to be sync pulses.
Sync Threshold adjustment is occasionally necessary when a DVD player or HDTV source
signal drops “below black” (for example, during scenes with explosions or when subtitles
are present) and causes the projector to temporarily lose sync. If the sync level from the
source is persistently too low, the display device won’t sync with the source at all.
The range is from 0 (approximately 60 millivolts (mV)) to 15 (approximately 300 mV).
HDMI:
Select HDMI from the Service menu to set the following options affecting
communication between HDMI sources, the DHD Controller and the Q-750d Ultra.
• HDMI EDID Exten
s
ion:
Extended display identification data (EDID) is a data
structureprovided by a display device to describe its capabilities to a graphics card. It is
what enables a modern personal computer to know what kind of monitor is connected.
Some modern display devices provide more information via EDID than others, in the
form of “extensions.” Some computer graphics cards do recognize or properly interpret
this extended EDID information.
Select HDMI EDID Extension from the HDMI menu to specify whether or not the EDID
extensions from the display device are passed through to the sources connected to the
HDMI 1, HDMI 2, HDMI 3 or HDMI 4 inputs. By default, the extensions are on. Change
these settings only if HDMI EDID incompatibility issues arise.
• Audio Format:
Select Audio Format from the HDMI menu to choose an option for
routing the audio signal from an HDMI source. With the Q-750d Ultra, the
recommended setting is
HDMI Out (Audio Only)
. (This is the default setting.)
• CEC:
This control chooses whether or not the DHD Controller responds to HDMI CEC
control messages from a disc player, set-top box or other HDMI source. It also enables
or disables CEC communication between the DHD Controller and projector.
The default (and recommended) setting is
On
. For more information about CEC, refer
to
Using HDMI CEC Messages
on page 106.
• HPD Toggle Rejection:
Select HPD Toggle Rejection from the HDMI menu to specify
whether or not the DHD Controller ignores extraneous Hot Plug Detect (HPD) signal
state changes from a downstream HDMI device (third-party display or audio/video
receiver).
The default setting,
Auto
, disables HPD toggle rejection on the Q-750d Ultra. Use the
other settings to troubleshoot compatibility issues or reduce the amount of time
needed to lock to an incoming signal.
1. Setting
CEC
to
Off
should be done only for troubleshooting
purposes.
2. The DHD Controller does not transmit HDMI CEC control
messages from the “HDMI Audio Out” connector.
Note
Содержание Quantum Color Q-750d Series
