Runco LightStyle LS-100d, Руководство по установке и эксплуатации

Страница: 75 / 114

Operation
Lightstyle™ Series LS-100d Installation/Operation Manual 59
PRE
L
IMINAR
Y
If you prefer to do this manually, set it to Off. The DHD Controller will ask if you want
to perform the upgrade the next time it is power-cycled.
• Check For New Firmware: To have the DHD Controller check for new firmware on
demand (and perform an upgrade if it finds a new version), select Check For New
Firmware from the Auto Firmware Upgrade menu. If the DHD Controller finds a new
firmware version, select
Ye s to perform the upgrade or No to return to the previous
menu.
• E-Mail Notification: Select E-Mail Notification from the Network menu to specify
when and to whom the DHD Controller sends error and service notification messages
via e-mail.
The notification messages are in the following format:
To: [E-Mail Address; see below]
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DHD4
Body:
This is an automated message sent from the Runco DHD4:
Notification: [One of the following:
“DHD Error” / “Display Error”
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]
Detailed Description: [ If a DHD Error, one of the following:
“Fan Failure 1” / “Fan Failure 2”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”
If a Display Error, a device-specific
error message such as “Lamp Door Open”
If a Periodic Service Notification, the elapsed
time since the last notification
If a Lamp Life Notification, the number of hours
the lamp has been in service
If a Calibration Data message,
“See Attached File” ]
Serial Number: [DHD Controller serial number]
Customer Information: [From “Customer Information“ sub-menu;
see below]
Best Regards,
Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
• E-Mail Addre ss : To specify the destination e-mail address for error and service
notifications, select E-Mail Address from the E-Mail Notification menu. The
procedure is similar to that for setting the IP address (refer to
IP Configuration on
page 58). Enter up to 45 alphnumeric characters.