Hardware Installation and Reference Guide
Installing the Switch
59
3.3.2
Mounting the Switch on the Wall
RG-ES106D-Pand RG-ES110D-P can be mounted on the wall. (Mounting screws and wall anchors are
customer supplied.)
In actual installation, users need to determine the size and depth of the two mounting holes on the wall based
on the sizes of wall anchors and screws. Ensure that the wall anchors can be inserted into the holes, only the
outer edges of the wall anchors are left outside the wall, and screws can be tightly fastened to the wall.
Installation Steps
The following process takes RG-ES110D-P as an example. The steps of mounting the switch on the wall are as
follows:
(1) As shown in Figure 3-4, drill two holes 97.6 mm (3.84 in.) far away from each other, and the line of
connecting the two holes is horizontal.
(2) Insert wall anchors into the holes and ensure that the outer edges of the wall anchors are aligned with the
wall.
(3) Put screws (ST4.2x20 recommended) into the wall anchors and ensure that the distance between the inner
side of the screw head and the outer edge of the wall anchors not be smaller than 2.5 mm (0.10 in.) so that
the device can be securely mounted on the screws.
(4) Align the two mounting holes on the bottom of the chassis of the device with the screws, and then fasten the
device on the screws.
