Ruijie Networks RG-S6200 Series, Руководство по установке

Страница: 29 / 41

Figure 2-2 Installing the power module
Insert the power module smoothly. Please pay attention to the direction of the power panel to avoid the wrong
insertion. If the position is not proper, you must withdraw the inserted module and then re-insert it.
3.4.2.2 Removing the Power Module
The process of removing the power module is reverse to the installation.
Step 1: Wear the anti-static gloves. Press the plug of the power module and hold on to the module handle with one
hand to pull it out slightly. Then hold the end of power module with the other hand to pull it out uprightly and slowly.
Step 2: Install the blank panel of the power supply. Put the power module into its package.
In the process of pulling out the M6200-AC650I-F(R) power module, you need to hold the handle of the power
module with one hand, and hold the end of the power module with the other hand to remove it slowly. The blank
panel of the power shall be installed on condition that no other power module is installed on the location where the
power module is removed, to ensure the normal ventilation and dissipation and avoid the dust for the chassis.
3.4.3 M6200-FAN-F(R) Fan Module Installation
3.4.3.1 Installing the Fan Module
Step 1: Wear the anti-static gloves, take a new fan module from the package, and confirm that the air input direction
is consistent as needed.
Step 2: Dismantle the blank panel of the fan supply, take the plane with the PCB in vertical view as the top plane,
hold the end of the fan module with both hands, insert it to the chassis slowly along the guide rail until it is fully
seated, and make sure that it is in good contact with the its slot, as shown in Figure 2-4.