3.4 Module Installation
3.4.1 M6200-16XS Extension Module Installation
3.4.1.1 Installing the Extension Module
When installing the extension module, note that:
1.
Power off the switch before installing the extension module because it does not support the hot-plugging.
2. Wear the anti-static gloves, and then remove the blank panel of the extended port of the front panel of the
RG-S6200.
3.
Align the M6200-16XS to the guide rail of the extended port, and push it to the switch along the rail horizontally
and slowly. When hearing “da”, which means the extension module is inserted into the switch closely, fix the
screws on the transition board. During the insertion, if you cannot push the module, please push out the module
and align it to the guide rail again. Do not push the module forcibly and roughly!
4.
Select 10G optical port as required. For the 10G optical port, please select the corresponding SFP+ modules
and jumper. (refer to Optical Module type and Transmission Distance Supported )
5. SFP+ optical module supports the hot-plugging. To replace an optical module, you can do it during the
operation.
6.
Arrange optical fibers properly to avoid being pressed by heavy goods or disconnected by foots.
3.4.1.2 Removing theExtension Module
The process of removing the extension module is reverse to the installation.
1.
Power off the switch before removing the extension module because it does not support the hot-plugging.
2.
Wear the anti-static gloves, and then loosen the plug board screws of the extension module to be replaced with
the screwdriver. Pull-out the M6200-16XS extension module along the rail horizontally and slowly.
3. Install the blank panel of the extended port of the front panel of the RG-S6200 and put the M6200-16XS
extension module into the package.
3.4.2 RG-M6200-AC650I-F(R) Power Module Installation
3.4.2.1 Installing the Power Module
Step 1: Wear the anti-static gloves. Take a new power module from the package. Confirm that the input mode and
input index of the power module are consistent with the requirement.
Step 2: Dismantle the blank panel of the power supply, take the plane with power information printed as the top
panel of the power module. Hold the handle of the power module with one hand, and hold the end of the power
module with the other hand to insert it to the chassis along the guide rail uprightly and slowly until it is fully inserted,
and make sure that it is in good contact with the power slot, as shown in the Figure2-2.
Содержание RG-S6200 Series
