RuiDa RDC6585G, Руководство пользователя

Страница: 48 / 73

RDC6585G Control System Manual V1.0
SHENZHEN RUIDA TECHNOLOGY 41
press <Origin> key to set the current coordinate value to the location point 1, and finally press
<Shift> key to return to the current interface operation. The operation process interface is as
follows:
Other origins are set in the same way.
When the "Select Block" stops on the "Start origin" entry, press the <Enter> key to enter the
modification, press the "Up/Down" key to modify, after the modification, press the <Enter> key, the
parameters automatically take effect, and press the <Esc> key to return to the menu interface.
Each item introduced as below:

Multiple Origins Enable: “Yes” or “No” can be selected. If you select “No”, the
system will use the single-origin logic. You can press the <Origin> key and set the origin,
and only this origin can become valid. If you select “Yes”, the system will use the
multiple- origin logic and the
<Origin> key on the keyboard become invalid. In such a
case, the parameter of each origin must be set in the menu as follows.

Origin Enable1/2/3/4: after the multiple-origin logic is enabled, the four origins
can independently be prohibited and enabled.

Start Origin: there are such five digits as 0~4 for option, which are the origins
to be used for the next figure. Origin 0 means the origin set by the <Origin> key on the
panel in the single- origin logic. 1~4 means the serial number of the origins in the
multiple- origin logic. Start origin can be modified to any one of origin 1~4, so as to
control the start location of next work (the premise is that the origin is enabled), but it
can’t be modified to origin 0.
Figure 8.5.3-2