RuiDa RDC6585G, Руководство пользователя

Страница: 44 / 73

RDC6585G Control System Manual V1.0
SHENZHEN RUIDA TECHNOLOGY 37
to select a parameter category such as "carving", "feeding" and so on. The right parameter area
displays the corresponding parameters. If the user does not need to modify the parameters, press
the
<Esc>
key to return to the menu interface.
If the user needs to modify the parameters, press the <Enter> button, and the "blue selection
block" switches to the first parameter in the parameter area, as shown in the following interface:
At this point, the user can press the "up/down" key to select a parameter, press the number key to
modify the numerical parameters (such as "Idle speed"), for non-numerical parameters (such as
"Scan mode"), when the "blue selection block" stops on the parameter, press the
<Enter> key to
enter the modification mode (the "blue selection block" right side becomes ), press the
"up/down" key. Modify the parameters. After the modification, press the <Enter> key to exit the
modification mode. When the current page parameters have been modified, move the "blue
selection block" to the "Write" entry and press the
<Enter> key. The panel saves all the
parameters on the motherboard and takes effect, and displays the save progress on the "Write"
entry. If the user wants to verify that the parameters are saved successfully, he can move the "blue
selection block" to the "Read" entry and press the
<Enter> key, then the panel reads the
motherboard parameters again and displays them. When pressing the "left/right" key, the Blue
Select Block switches back to the parameter category, as shown in Figure 8.5.1-1, where the user
can select another parameter category to modify or press
<Esc> to return to the menu interface.
Other interface operations are similar, and the interface is displayed as follows:
Figure 8.5.1-2