RuiDa RDC6585G, Руководство пользователя

Страница: 24 / 73

RDC6585G Control System Manual V1.0
SHENZHEN RUIDA TECHNOLOGY 17
4.8 Input Port CN4
Pin Symbols Definitions
1 GND
Power ground (output)
2 Stop
Stop key input, used to stop the running work
3 Shot Input for manual laser on/off. Low level is to open laser
and high level or no-connection is to close laser.
4 Door
Input from protective port. If the machine needs to be
protected in the special state (such as door open protection),
the protective signal can be inputted from this pin. This pin can
be enabled and prohibited. This signal is not inquired by the
mainboard if this pin is prohibited; if this pin is enabled, when
the input is high-leveled or this input port is suspended, the
machine will be protected, the work suspended and the laser
closed.
5 Foot
Input port of foot switch. The connection method is: when the
pedal is stepped down, the low-level signal will be inputted to
this port; when the pedal is released, the port will be
disconnected or the high-level signal can be inputted to this
port; when the stepped-down pedal is held for not less than
100 ms, if the machine lies idle, it can be started for work; if
the machine is in the working state, the work will be
suspended; of the machine is in the suspension, the work will
be restarted, that is to say, the function of the pedal switch is
the same as that of the “Start/Pause” key. If the interval time to
the first stepping-down of the pedal should be less than
100ms when the pedal is stepped down once again, the
second stepping-down of the pedal will be considered invalid
by the mainboard.
6 IN1
Reserved input
7 IN2
Reserved input
8 IN3
Reserved input
9 IN4
Reserved input
10 +24V
24V Power positive output
4.9 8-axle Spacing Input Interface
X/Y axle spacing input X/Y-Lim:
Pin Symbols Definitions
1 GND Power ground (output)
2 LmtY-
The spacing from axle Y- and Y to 0 coordinate
3 LmtY+
The spacing from axle Y+ and Y to max. coordinate