RDLC320 Controller User Manual
39 / 45
© 2016 Ruida Technology. All Rights Reserved.
X- axis Startup Reset
Y- axis Startup Reset
Z- axis Startup Reset
U- axis Startup Reset
You can select “Yes” or “No” in the field of the above four parameters, which is used to confirm
whether each axis should be reset on the startup.
(4) Go Scale Parameters Setting
Go Scale Mode
: “close laser go scale” means idling, for frame preview; “cutting frame open
laser” means that cut off the well-processed graphics manually; “4-corner Dotting” means to emit
the light at four corner points of the frame, laser one point and the other places turning off. The
size and position of this graphics can be checked intuitively through the four points. The speed is
the speed value set on the keyboard when the system is idle. For light output, its
minimum/maximum power is the corresponding value set on the keyboard when the system is idle
(The laser power on the 4-corner dotting means the setting maximum power).
Go Scale Blank Distance
: It means whether to extend a certain length outside the actual frame of
the figure on the preview/cutting of frame.
If the frame crosses the border, the interface will prompt it. If the Enter key is
pressed at this time, the system will cut the border at the maximum/minimum
coordinates, and then framing operation. This operation can be given up.
(5) Other User Parameters
Array Mode
: Two-way array or one-way array can be selected, only be effective for virtual array.
Two-way array means cutting the array back and forth in sequence; one-way array means the
cutting the array always from one direction to another. When in one-way array, the action mode
and fluency of each array elements are completely the same, which takes a little more time than
two-way array. Two-way array is the default option.
Return Position
: The locating point and the machine origin point can be selected. This parameter
decides the parking position of laser head after each processing.
Delay before Feeding
: set the time: 0~300s. The lagged time can facilitate user’s feeding and
picking on the feeding device. The previous work is completed and delayed the value, the feeding
axis begins to move. During the period of delay, it is convenient to feeding and select material for
Prompt
