Resetting the CM to Factory Default Settings
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
45
Resetting the CM to Factory Default Settings
CAUTION!
Performing this procedure resets the CM part of the T504 to its factory
default settings.
If you want to reset the AP and CM components to their factory default settings,
then perform the procedure described in
“Rebooting and Resetting the AP and CM”
instead.
You can use SNMP on either the access point or cable modem to reset the CM to
factory default settings. The procedure is the same, regardless whether you perform
this operation from the AP or CM.
NOTE
Before starting this procedure, you must first obtain the related MIBs from
Ruckus Wireless. Contact your authorized Ruckus Wireless sales representative or
Ruckus Wireless Support. Visit
http://support.ruckuswireless.com/
contacts
for Ruckus Wireless Support contact information (login required).
1
Connect the administrative computer to the same network as the T504.
2
Start your MIB browser.
3
Load the Ruckus Wireless MIBs onto the MIB browser.
4
In the MIB browser, specify the IP address of the T504 access point or cable
modem. (You can obtain this information from the DHCP server on the network.)
5
Find the OID
1.3.6.1.4.1.25053.3.1.4.7.3
(ruckusZFT504ControlLED).
6
Set the value to
15
(factoryResetCM).
You have completed resetting the cable modem to factory default settings using
SNMP.
DRAFT
