Ruckus Wireless T504, Руководство по установке

Страница: 20 / 48

Installing the T504
Deploying the T504
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
21
Deploying the T504
In this section, you will mount the T504 in its final mounting location. Perform the
following:
• Mounting the T504
• Earth Grounding the T504
• Installing the Cable Power Tap
• Powering the T504 with POC
• Checking the Signal Level with an RF Power Meter (Optional)
• Configuring the T504 for the First Time (Optional)
Mounting the T504
To mount the T504 assembly on a cable strand, you need to secure the cable
clamps that are attached to the strand interface to the cable strand.
1 Slightly loosen the nuts that fasten the two cable clamps to the strand interface,
enough for the strand support cable to fit into the cable clamps.
2 Place the cable clamps on the strand support cable.
3 Tighten the two cable clamp nuts to 22 to 27 N.m (16 to 20 ft-lbs) to secure the
mounting.
You have mounted the T504. Continue with Earth Grounding the T504 .
Earth Grounding the T504
The cable strand is usually earth-grounded, and mounting the T504 on the cable
strand earth grounds the T504 chassis as well; if this is the case, skip this procedure
and continue with
Installing the Cable Power Tap .
CAUTION! Be sure that earth grounding is available and that it meets local and
national electrical codes. For additional lightning protection, use lightning rods and
lightning arrestors.
.
If the cable strand is not earth-grounded, then continue with the following:
1 The color coding of ground wires varies by region. Before completing this step,
check your local wiring standards for guidance.
2 Using the factory-supplied ground screw and washers, use the factory-supplied
earth ground wire with ring terminal to connect a good earth ground to the T504
using the chassis ground screw shown in
Figure 4 .
DRAFT