RTX RTX2018, Руководство пользователя

Страница: 27 / 34

Date: 09-May-2019
Product name RTX2018
File : RTX2018 User Manual 1.0.docx Ref.: FHA Page: 27 of 34
This document and the information contained is property of RTX A/S, Denmark, and should be regarded as confidential.
Unauthorized copying is not allowed. The information in this document is believed to be correct at the time of writing. RTX A/S
reserves the right at any time to change said content, circuitry and specifications.
•
GFSK (A+B field) in the “ TX GFSK ” tab
•
PI2-DBPSK in the A-field on the “ TX PSK ” tab
•
B-field modulation as selected in the “M odulation ” box
•
Slot type as specified in the “Slot Type” menu
•
Channel is specified in the “ Channel ” field
•
Antenna selection is chosen in the “ Antenna ” box
•
The Bit pattern in B-field (either Fig 31 or Static Pseudo Random Sequence, SPSRB) is
as selected in the
“ Bit Pattern ” box
5.5
TX GFSK Measurement Results
The measurement results for the GFSK are shown in
Figure
16
6 below.
Figure 16. TX GFSK results
After the setup has been completed, the measurement can be initiated by pressing either the
“Single” or “Continuous” buttons.
“Single” will capture and analyze a single burst.
“Continuous” will capture and analyse a burst continuously until “Stop” is pr essed
The output is:
•
“Status” shows the TX measurement status which can be “Idle” or “Running”
•
“TX Power” shows the TX power measured in dBm evaluated in the “Evaluation
Window”.
•
“Freq Offset” shows the frequency offset measured in kHz of the signal evaluated in
the “Evaluation Window”. The modulated signal is estimated and subtracted, so that
the frequency offset will not be affected by unbalanced numbers of 0 and 1 in the
signal.
•
“Freq Deviation” shows the peak frequency deviation me asured in kHz of the signal
within the “E valuation Window ” . Please note that in cases of a very large and