Date:
09-May-2019
Product name
RTX2018
File
: RTX2018 User Manual 1.0.docx
Ref.: FHA
Page: 19 of 34
This document and the information contained is property of RTX A/S, Denmark, and should be regarded as confidential.
Unauthorized copying is not allowed. The information in this document is believed to be correct at the time of writing. RTX A/S
reserves the right at any time to change said content, circuitry and specifications.
“c:
\RTX2018\
”
The slider
is used to “Enable” or “Disable” the RF generator.
The
RF output level controlled either by entering a numeric value in the “Level” box or by the
by slider below.
The range is from -100 to -
10 dBm. The “Cable
L
oss” is
considered before the value is
transmitted to the CMW100.
Figure 8. RX setup details
5.2.4
DUT Interface
The DUT interface is used to configure and control the DUT. If the “
Rtx
Prodtest DLL” button is
pressed, a file dialog box is opened to allow the user to select another RTXProdTest.DLL
” file.
The DUT interface can only work if the DUT is utilizing an RTX-supplied firmware
(
Note 1
)
.
The default “RTXProdtest.dll” will work for most products.
It is located in the RTX2018 folder.
