RTW DigitalMonitor 10500X-PLUS, Руководство по эксплуатации

Страница: 241 / 251

RTW DigitalMonitor 10500X-Plus 241 Appendix A: Specifications
Appendix A: Specifications
General
Supply voltage: 24 V DC ±10 %
Current drain nominal: 290 mA
Note:
Please note that the momentary switch-on current is considerably higher
than the nominal current!
Operating temperature range: 0° to +45° celsius
Digital input: 1 (Stereo), AES3, transformer balanced
Input impedance: 110 Ω or Hi-Z
Sampling frequency range: 32 kHz to 96 kHz
Digital output: 1 (Stereo), AES3,
input signal looped through, unbuffered
Connectors: 1 x 3-pin XLR-F
1 x 3-pin XLR-M
1 x 15-pin Sub-D (VGA)
1 x flange connector type Binder 710 (DC)
Dimensions/weight: 176,5 x 125,5 x 61,5 mm/approx. 800 g
Display
Display: VGA color TFT, 640 x 480 pixel, 132 x 99 mm
Colors: 8
Reversal direction: 12 o’clock
Viewing angle: horizontal 60° typ., vertical 60° typ.
Contrast: 250 at reversal direction
Note:
The built-in display has a high resolution (640 x 480 pixel). Even with the
most advanced techniques, a small number of pixel defects is inevitable.
The manufacturer of the display specifies a maximum of 6 active or pas-
sive pixel defects. RTW guarantees these specifications to be met by
their products.
Program Meter: Digital Peakmeter (PPM)
Level display: 2 channels, peak hold indicator switchable,
vertical display orientation
Viewing area: 50 x 98 mm (W x H)
Bargraph length: 90 mm
Display modes: 1 x Stereo
Peak value memory: maximum peak level, peak hold
Numeric level display: selectable, shown on the lower left side of
the display
Correlator spot indicator: switchable (at the bottom of each bargraph
pair on the left)
Loudness meter: additional spot indicator displayed on the
bargraphs of the level display, RTW mode
or A-, C-, RLB, CCIR-2k weighting, RMS