RTS RVON-I, Руководство пользователя

Страница: 6 / 40

Introduction
2
Reference View
FIGURE 1.
RVON-I/O Reference View
l
O
OPEN
OPTIONS
CLOSED
GPI/O
SERIAL PORT
RELAY 1 & 2
J4
J3 J2 J1
I/O 8
I/O 7
I/O 6
I/O 5
I/O 4
I/O 3
I/O 2
I/O 1
FAIL
ETHERNET
90 - 240 VAC
TELEX
®
TELEX COMMUNICATIONS, INC.
MADE IN U.S.A.
DIP Switch 1-4
Ethernet Connection
via RJ-45
RVON-I/O
Reset Power
1
8
16
24
1 2
LED indicator displays
green when device is
powered ON
Reset IP Address
Push buttons 1&2 at the same time
while resetting the
device
Fail LED -
Microprocessor
did not initiate.
Power ON and OFF/
AC Power Plug
Resets the device
LED device status
module, for more detailed
information, see Table 7.
GPI/O Connection
25-pin DB-25 Connector
Relay Connection
DB-9 Connector
Serial Connection
DB-9 Data
Port
}
J1 through J8
I/O Connections
used to pass audio and data to
keypanels and Matrices.
DB-9 Balance IN and OUT.
LED Explanation of the LED device status module
# Red LED Green LED
1
VOIP not connected
channel 1 VOIP connected
Channel 1*
2
VOIP not connected
channel 2 VOIP connected
Channel 2*
3
VOIP not connected
channel 3 VOIP connected
Channel 3*
4
VOIP not connected
channel 4 VOIP connected
Channel 4*
5
VOIP not connected
channel 5 VOIP connected
Channel 5*
6
VOIP not connected
channel 6 VOIP connected
Channel 6*
7
VOIP not connected
channel 7 VOIP connected
Channel 7*
8
VOIP not connected
channel 8 VOIP connected
Channel 8*
9 GPO 1 asserted GPI 1 asserted
10 GPO 2 asserted GPI 2 asserted
11 GPO 3 asserted GPI 3 asserted
12 GPO 4 asserted GPI 4 asserted
13 GPO 5 asserted GPI 5 asserted
14 GPO 6 asserted GPI 6 asserted
15 GPO 7 asserted GPI 7 asserted
16 GPO 8 asserted GPI 8 asserted
17
18
Pass-Through Serial TX
Activity Pass-Through Serial
RX Activity
19
20
Shell Log Message (TX)
Activity
21 Ethernet Half Duplex Ethernet Full Duplex
22 Ethernet 10 Mbps Ethernet 100 Mbps
23 Ethernet Not ‘AUTO’ Ethernet Link Good
24 Remote Mode Processor Good
*Green LED wink periodically when a keypanel is connected.
** If both LEDs are OFF or not lit, the channel is NOT
configured (this only applies to LEDs 23-16).