RTS KP-4016, Техническое руководство

Страница: 249 / 306

KP Series KP-4016/5032 Menu System 249
Bosch Security Systems, Inc. Technical Manual F.01U.304.914 Rev. 05
4.
Press the SEL button .
Disabled and Enabled appear in the panel display.
5.
Using the arrow buttons, select Enabled .
6.
Press the SEL button .
7.
Press the CLR button to exit the menu.
To configure the OKP device name , do the following:
1.
Starting at the Service|OMNEO Setup menu, select OKP .
2.
Press the SEL button .
Device Name, DHCP, and IP Parameters appear in the panel display .
3.
Using the arrow buttons, select Device Name .
The name of the OKP card appears in the panel display with the first character of its name blinking .
4.
Using the up and down arrow buttons or the Aux shaft encoder, select a new character at the current position .
5.
Using the left and right arrow buttons or the Main shaft encoder, move to the next or previous character position .
6.
Press SHIFT to insert a character at the current position.
7.
Press the SEL button .
OR
Press the
AUX shaft encoder to move to the next character.
NOTE: Press BACK or press the MAIN shaft encoder to cancel editing. A confirmation is required.
8.
Press FWD or move to the end of the name and Press the SEL button (or the AUX shaft encoder) to save changes.
9.
Repeat steps 7 and 8 until you have modified the device name.
10.
Press FWD .
The message Save Name? appears on the panel display.
11.
Press the SEL button .
To configure the OKP IP Address , do the following:
1.
Starting at the Service|OMNEO Setup menu, select OKP .
2.
Press the SEL button .
Device Name, DHCP, and IP Parameters appear in the panel display .
3.
Using the arrow buttons, select DHCP .
4.
Press the SEL button .
Disabled and Enabled appear in the panel display.
5.
Verify DHCP is disabled .
NOTE: When making changes to the OKP IP parameters, DHCP must be disabled before changing the Domain
name or IP Address. If DHCP is enabled, you can still view the IP Parameters, but you cannot make changes
to them.
6.
Press BACK .
7.
Using the arrow buttons, select IP Parameters .
NOTE: SEL/FWD moves to the next octet, unless already on the last octet, in which case it save the current IP
Address. CLR/BACK moves to the previous octet, unless already on the first octet, in which case it cancels
editing of the IP Address.
8.
Press the SEL button .
IP Address, Gateway, Netmask, DNS Server, and Domain appear in the panel display.
9.
Press the SEL button .
The IP Address appears with the first octet blinking in the panel display.
10.
Using the number pad, enter the first octet number in the IP Address.