RSP P1001, Руководство по эксплуатации продукта

Страница: 25 / 38

M0109-1 ver 2.2 25
4 MAINTENANCE AND SERVICE
4.1 Maintenance chart
The tool changer and tool attachment must be maintained regularly to ensure
proper function. The specified intervals are approximate and valid under normal
conditions. Under extreme conditions, such as dirty environments or extreme
robot movements, the intervals should be shortened.
Consider the table as a guide and update as your production experience of each
system increases.
WARNING!
Risk of getting squeezed between piston and ball holder when the piston is taking
closed position.
NOTE!
Only perform work on grippers or tools attached to the tool changer if the air
pressure is safely switched off.
NOTE!
Tool changers must only be dismantled and repaired by Robot System Products
during the warranty period. Otherwise the warranty will not be valid.
4.1.1 Required products
Product Specification Note
Grease,
3HXG1000-413 Magnalube-G, Teflon
grease O-rings
Grease I0876 MolykoteBR2Plus Locking balls.
Cleaning agent Denatured alcohol or
similar Signal pins at tool changer and
signal contacts at tool
attachment.
Cleaning agent Denatured alcohol or
similar For tool changer and tool
attachment.
Glue Loctite 480 (or similar) For gluing the air sealings.
Cloth Lint free cloth For cleaning.
NOTE!
Chemical resistance protective gloves are recommended when using grease or
cleaning agents such as denatured alcohol. Safety goggles are recommended
when working with cleaning agents such as denatured alcohol. Adequate
ventilation should be provided when chemical substances are used.