RSP P1001, Руководство по эксплуатации продукта

Страница: 22 / 38

22 M0109-1 ver 2.2
3.3 Installation of tool changer on robot
Action Note
1 Safety Read the safety section (1.1).
2 Service position Place the robot in service position.
3 Power off Switch the power off and lock the
circuit breaker.
NOTE! Read the safety chapter for the
robot.
4 Mount guide pin Press the enclosed guide pin into the
robot flange.
Alternatively, if adaptation plate is
used
:
Mount the adaptation plate on the robot
flange (see tightening torques above).
Press the enclosed guide pin into the
adaptation plate.
5 Fit tool changer Lift the tool changer to the robot flange
(or adaptation plate). Make sure that
the guide pin is fitted to the guide hole
in the tool changer.
WARNING! The tool changer may
cause personal injury and equipment
damage if dropped.
6 Mount tool changer Mount the tool changer with the
enclosed screws. Use an Allen key for
tightening (see tightening torques
above).
7 Connect air hoses Connect the air hoses according to
markings.
NOTE! Pneumatic diagram is found in
section 2.1.8.
8 Connect electrical signals (TC5-4E
only)
Connect signal contact M12 8p.
9 Power on Unlock the circuit breaker and switch
the power on.