![Roundup VCT-2010 Скачать руководство пользователя страница 4](http://html1.mh-extra.com/html/roundup/vct-2010/vct-2010_owners-manual_1492198004.webp)
VERTICAL CONTACT TOASTER
4
P/N 1011233 Rev. B 09/13
In addition to the warnings and cautions in this manual, use
the following guidelines to safely operate the unit:
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with a
properly grounded cord connector. Do NOT attempt to
defeat the grounded connector.
• Install or locate the equipment only for its intended use
as described in this manual. Do NOT use corrosive
chemicals in this equipment.
• Do NOT operate this equipment if it has a damaged
power cord or plug, if it is not working properly, or if it
has been damaged or dropped.
• This equipment should be serviced by qualified per-
sonnel only. Contact the nearest Authorized Service
Agency for adjustment or repair.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse the power cord or plug in water.
• Keep the power cord away from heated surfaces.
• Do NOT allow the power cord to hang over edge of a
table or counter.
The following warnings and cautions appear throughout
this manual and should be carefully observed:
• Turn the power off, unplug the power cord, and
allow unit to cool down before performing any
service or maintenance.
• The toaster should be grounded according to local
electrical codes to prevent the possibility of electri-
cal shock. It requires a grounded receptacle with
separate electrical lines protected by fuses or a
circuit breaker of the proper rating.
• Bread may burn. Therefore toasters must NOT be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe
operating distances may cause discoloration or
combustion.
•
When installing a Silicone Belt, do NOT install
it around the Upper and Lower Support Rods or
permanent damage to the Silicone Belt will occur.
Make sure the Silicone Belt is only installed around
the Conveyor Belt Chain.
• Make sure both ends of the Silicone Belt are
aligned before installing the Silicone Belt Pin.
•
Failure to use Release Sheets may result in damage
to the equipment and loss of warranty coverage.
• Do NOT clean this appliance with a water jet.
• If the power cord is damaged, it must be replaced
by the manufacturer, its service agent, or a similarly
qualified person.
• All electrical connections must be in accordance
with local electrical codes and any other applicable
codes.
•
WARNING, ELECTRICAL SHOCK HAZARD.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH.
- Electrical ground is required on this appliance.
- Do NOT modify the power cord plug. If it does
not fit the outlet, have a proper outlet installed
by a qualified electrician.
- Do NOT use an extension cord with this unit.
- Check with a qualified electrician if you are
unsure if the appliance is properly grounded.
IMPORTANT SAFETY INFORMATION