VERTICAL CONTACT TOASTER
26
P/N 1011233 Rev. B 09/13
1
With power off and toaster cool, set crown and heel
compression knobs to 6 & 6. Remove top cover and both
conveyor covers. Remove current belts by either removing lacing
pin or using scissors or razor knife, carefully cut the belt free of
the wire, drive belt.
Installing the VCT 2010 Clip Style Belt
3
Hook the bottom of each clip to wire belt and gently push
the top of the belt upward to clip the top of the clip to the
next metal wire. Make sure clips are fastened to the center
section of the wire belt.
2
Pick belt up from the center and feed flap end beneath
yellow bar and lower belt until the other end of the belt is
on the bottom of the toaster. Feed belt from the bottom through
bottom yellow bar until both ends are approximately in the
middle of the toaster.
4
Assure both clips are attached using two wires only to the
wire belt. Then
position both ends of the new belt together
and line up so the lacing is even. Insert the pin to join both sides
of belt together.
5
Verify belt alignment is even from side to side of each belt.
Set compression knobs to recommended settings of 4 for
the crown and 3 for the heel. Reinstall both conveyor covers and
top cover.
P/N 1011208 7/13
VCT-2010 Clip Style Belt Instructions
