Rottler SG10A, Руководство по эксплуатации и обслуживанию

Страница: 42 / 124

Section 4 Control Definitions SG10A Manual
www.rottlermfg.com
4-10
Options Screen
Dwell Options
After finish “cutting depth” in the “seat cutting” and “seat counter boring” mode the “dwell options” go into
effect. This means that after the finish cutting depth has been reached the machine will go to this stage.
500 RPM for 2 revolutions of the cutter then retract .020 at a rate of .0500. You can change all of these
figures buy taping the figure and entering in your own figures. Normally you shouldn’t have to change
the “vertical retract speed” and the “vertical retract distance” The “finish revolutions shouldn’t need to be
changed either, you will want a minimum of 2 revolutions here to clean seat after it has been cut. If you
enter to many revolutions cutter will drag and possibly cause chatter. Finish RPMs is the one you will
need to change the most. Start with 100 RPM above cutting speed used . if you hear or see chatter after
seat is cut, slow this down to cutting speed or below. Chatter usually goes away with a slower speed.
Retract Out Options
This is used in the reaming program. After “finish reaming depth” has been reached, the retract out
options go into effect. “Retract RPM” should be set at 100 “Retract Speed “ should be set at .5000 The
“Turn spindle while retracting “ box SHOULD be checked.
Peck Options
This works with all modes. It works well when making heavy cuts. Buy entering a number in the “Down
stroke” space the spindle will cut down this amount then come up the amount entered in the “upstroke”
space. Then repeat until finish cutting depths are reached.