Rottler SG10A, Руководство по эксплуатации и обслуживанию

Страница: 39 / 124

Section 4 Control Definitions SG10A Manual
www.rottlermfg.com
4-7
Seat Cut: Operations screen
Vertical Zero
This is the first step you need to do to set up your program. All of the height figures entered will start from
this position. This number represents the spindle vertical position. The “zero” position is when the cutting
insert first comes in contact with the seat it is cutting. To set this the head needs to be leveled and all
tooling set to cut. (This will be discussed in later chapter.)
You will want to set this on the highest seat. Float workhead and manually lower
spindle (with handwheel, press the .001 handwheel button and use handwheel,
pictured on right) into cutting position so cutting insert is close to seat but not
touching. Let workhead dwell for a couple seconds and then clamp workhead. Start
spindle and press the .001 handwheel button on top of page, lower spindle with
handwheel one click (.001) at a time until the cutter just comes into contact with seat.
Then back off 1 click and stop spindle. Press the yellow “VERTICAL ZERO” button
on top of page. A box will ask are you sure you want to vertical zero, press OK. You will notice that the
vertical box on left has changed to “0.000” Now the rest of the heights can be set.