Rottler SG10A, Руководство по эксплуатации и обслуживанию

Страница: 20 / 124

Section 2 Installation SG10A Manual
www.rottlermfg.com
2-11
Air Supply
It is very important the air source for the SG10A / SG80A machine be moisture free. Water and oil in the
line will result in early cylinder and valve failure. The factory recommends installing a water trap at the
machine. Attach an air source of at least 100 PSI to the appropriate intake in the small enclosure located
on the left rear of the machine near the bottom. Bellow you will see the Air regulator panel for the different
settings on the floating planes on the machine. And cabinet cooler air regulator.
Air Adjustments
Float
The float regulators are located on the left side of machine base. Marked “Work Head Air Float
Adjustment” If the work head is not floating properly it could be from too much or too little air from the
regulator. Starting with all regulators set at 1 bar with “workhead float” button activated, slowly turn all
up .5 bar at a time until workhead start to float. Pushing work head front to rear checking for stiff spots.
If workhead is dragging in the forward position, (workhead pulled closest to operator) raise the 2 front
regulators 1 mark until it floats without dragging. Same for rear. You may have to go back and forth a few
times to get this correct. If workhead is not dragging lower the PSI until it does and then raise 1 notch at
a time until it is free. Typically the front two regulators will be slightly higher than the rear two. Once the
correct float is established lock the regulators in place by pushing in on the blue adjusting knob.
Use as little air as possible to achieve correct floatation. Using too much air will / could cause
excessive movement of workhead.