Roto Patio Fold, Инструкция по установке, обслуживанию и эксплуатации

Страница: 20 / 92

20

April 2015

IMO_374_EN_v1 Roto Patio Fold Subject to change.
Security
Fabrication advice
Maximum sash sizes and weights
The technical data, application diagrams, and component classifications in
the product-specific documentation of the hardware manufacturer give
instructions on the maximum permitted sash sizes and weights. Here, the
component with the smallest permitted load bearing capacity decides the
maximum permitted sash weight.
ƒ 
Check compliance of the technical data, application diagrams, and
component classifications before the use of electronic data sets, and
especially their use in fenestration programmes.
ƒ  The maximum permitted sash sizes and weights must never be exceeded.
In the case of uncertainty contact the hardware manufacturer.
Specifications for profile manufacturers
The manufacturer of windows and/or balcony doors must comply with all
specified system-related dimensions (e.g. gasket gap dimensions or locking
-point distances). Furthermore, he must check these regularly and make
certain of them, especially on the first use of new hardware components,
during manufacture, in an ongoing manner up to and including the window
installation.
Specifications for fabricators
In the area of the support brackets, cut the reinforcements to mitre and
push forward into the sash edges. Do not place sashes with already fitted
hardware components against or on top of each other, thereby placing
stress on the projecting support brackets. Seal all the outer components
on the profile-side assembly surfaces to prevent moisture from entering.
NOTE!
The hardware components are designed in such a manner, that the
system-related dimensions can be adjusted, provided the hardware
can have an effect on these. If a deviation from these dimensions
is noticed only after the installation of the windows, the hardware
manufacturer is not responsible for any possible additional work
arising.
Composition of hardware
Burglary inhibiting windows and balcony doors require hardware which
fulfils particular requirements.
Windows and balcony doors for damp rooms, and those for use in environ-
ments with aggressive and corrosive air components require hardware
which fulfils particular requirements.
The resistance of windows and balcony doors to wind loads when closed
and locked depends on the actual designs of the windows and balcony
doors. Wind loads prescribed by law and standards (e.g. as per EN 12210 –
especially test pressure P3) can be dissipated by the hardware system.
The hardware combinations and installations appropriate for windows and
balcony doors in the previously mentioned areas should be specifically selected
and agreed with the hardware manufacturer and the profile manufacturer.
NOTE!
The guidelines of the hardware manufacturer relating to the
combination of the hardware (e.g. the use of additional stay arms,
the design of hardware for burglary-inhibiting sashes for windows
and balcony doors, etc.) are binding.