Roto-Mix Roto-Spread 532-16, Руководство пользователя, инструкции по установке и каталог запчастей

Страница: 22 / 49

Adjust Spread Pattern
(See figure 12)
The spread pans at the rear of the spreader can be set
for wide spreading or they can be hinged inward to
spread straight behind the spreader.
Adjust Pressure Switches
(See figure 13 & 14)
NOTE: PRESSURE SWITCHES ARE PRE-SET AT
FACTORY AND NEED NOT BE RESET UNLESS
BEING REPLACED.
Before attempting to do the following
procedures, be sure to clear the beater area and put
barriers around the back of the spreader to prevent
accidental contact with the beaters while they are
running.
Setting “Stall” Pressure Switches:
1. Block one of the beaters to prevent it from turning.
(only one beater at a time).
2. Engage PTO to start pump and observe the
warning horn. (it should be sounding).
3. The left hand beater (driver side) should be the L/H
(drivers side) pressure switch closest to the
spreader box. (See figures 13 & 14) Loosen set
screw on side of sleeve. Turn the adjusting
sleeve in (clockwise) just until the horn stops
sounding. Then turn the adjusting sleeve out
(c/clockwise) until the horn sounds again. Then
turn 1/4 turn more counter clockwise. Tighten set
screw. The switch should then be set.
4. Disengage the PTO and repeat the above steps
for the right hand beater, to adjust the R/H
switch.
Setting “Spread Light” Pressure Switch
1. With beaters free to run, engage PTO to start the
pump, run at full PTO speed.
2. The pressure switch for the “Spreading Light”
is located in front of the left hand beater
pressure switch (see figure 13 & 14).
3. Loosen set screw on side of sleeve. Turn
adjusting sleeve out (counter-clockwise) until the
“Spreading Light” lights up.
4. Then turn the adjusting sleeve in (c lockwise)
until the light goes out. Then turn the sleeve in 1
more turn after the light goes out. Tighten set
screw.
5. Disengage PTO.
Spreader Light
Pressure Switch
Left Beater
Pressure Switch
Right Beater
Pressure Switch
FIGURE 13. ADJUST REMOTE PRESSURE
SWITCHES
FIGURE 14. ADJUST MANUAL PRESSURE
Right Beater
Pressure Switch
Left Beater
Spreader Light
Pressure Switch
Page 22
FIGURE 12. ADJUST SPREAD PATTERN
Adjust Here