Roto-Mix Roto-Spread 532-16, Руководство пользователя, инструкции по установке и каталог запчастей

Страница: 17 / 49

Page 17
UNLOADING
KEEP AWAY AND KEEP OTHERS
AWAY FROM THE ROTATING BEATERS.
BEATERS CAN CRUSH, DISMEMBER OR KILL.
CLEAR THE AREA OF ALL
PERSONS BEFORE BEGINNING OPERATION.
1. Engage the tractor PTO to start the beaters and
increase engine speed to 1000 PTO RPM.
2. Raise the hydraulic rear gate completely up. See
figure 5.
3. Start the sliding gate.
4. When material begins discharging from the
beaters and the spreading light comes on begin
forward motion.
NOTE: Performing the preceding steps while moving
forward will minimize heavy discharge onto the field
during startup.
5. Plan application onto the field so that you do not
travel over previously spread manure which is
slippery. Travel cautiously on hills and slopes.
Proceed up and down slopes instead of along
them.
SHUT DOWN
1. When the load has been discharged, the
hydraulic control to the sliding gate will return to
neutral, OFF. Allow the beaters to operate for a
few seconds to clear out any remaining material
and then stop the PTO.
2. Start the sliding gate to return to the front of the
spreader. When it reaches the front the hydraulic
control to the sliding gate will return to neutral,
OFF.
3. Once the sliding gate moves forward to the stop
position, completely close the rear gate.
UNHOOK THE TRACTOR
1. Park the spreader on level ground. Put the tractor
in PARK, set the park brake, and turn the engine
off before dismounting.
2. Place wheel chocks in front and in back of two
spreader wheels on opposite sides to prevent the
spreader from rolling after the tractor is
unhooked.
3. Remove the PTO drive shaft yoke from the
splined tractor PTO shaft. Unhook the PTO
storage chain from the slotted storage bracket
and pivot the PTO drive shaft up and into the
storage bracket. Reconnect the storage chain in
the slotted storage bracket to secure the PTO
shaft.
4. Remove the hydraulic hose ends from the tractor
hydraulic ports and store the hose ends in the
slotted hose storage brackets to keep them from
dragging on the ground. See figure 4.
5. Crank the spreader jack down until the spreader
hitch lifts off the tractor draw bar.
6. Remove the hitch pin.
7. Unhook safety chain from tractor drawbar
support. See figure 4.
8. Slowly drive the tractor away from the spreader.
STORAGE AND CLEANING
DISCONNECT PTO DRIVE SHAFT AND
HYDRAULIC HOSES BEFORE CLEANING,
ADJUSTING, LUBRICATING, OR SERVICING THIS
MACHINE.
1. The spreader must be thoroughly cleaned for
extended storage. Manure is acidic and will
damage paint and cause rusting of metal
components.
FIGURE 5. HYDRAULIC REAR GATE AND
SLIDING GATE
HYDRAULIC REAR GATE
IN RAISED POSITION
SLIDING GATE AT
REAR POSITION
REAR GATE CYLINDER,
BOTH SIDES