Roto-Mix Roto-Spread 532-16, Руководство пользователя, инструкции по установке и каталог запчастей

Страница: 12 / 49

TRACTOR HYDRAULIC SYSTEM RECOMMENDATIONS
10 GPM Minimum
2000 to 3750 PSI Operating Range
Hydraulic system should be self purging.
FEATURES
Capacity: 530 Cubic Foot- Heaped; 385 Cubic Foot- Struck Level; 2880 Gallon
Patent Pending Belt & Retention Gate System
Hydraulic Motor & Planetary Gearbox For Belt & Retention Gate System- Operates From Tractor Hydraulics
5/16” 350 psi PVC Belt
C102.5 Combination Chain for Belt & Retention Gate Drive System
Hydraulic Operated End Gate
9000# Drop Leg Jack
150 HP Tractor (Minimum)
1000 RPM PTO Drive
6’ Wide x 16’ Long Inside Dimension
High-Density Polyethylene on Floor, Side Walls, and End Gate
Two High Speed Vertical Beaters with Spinners, Flighting & Kickers
Independent PTO Driven Hydraulic Pumps & Motors For Beater Drive System
Adjustable Wings on Beater Assembly for Variable Discharge Width
Heavy Duty Tube Frame Trailer
Oscillating Tandem Axle Undercarriage with 4-12,000# Spindles & Heavy Duty 10 Bolt Hubs
4-15 x 22.5 Recap Tires With 10 Bolt Wheels
OPTIONAL EQUIPMENT
4- New 23.1L x 26”- 16 Ply Diamond Tread Tires with 10 Bolt Wheels- ILS
4- New 28L x 26”- 16 Ply Diamond Tread Tires with 10 Bolt Wheels- ILS
PRINCIPLE OF OPERATION
Two vertical spinning beaters at the rear of the spreader expel manure in a uniform spread pattern. Each beater is
driven by a hydraulic motor. A PTO driven hydraulic power supply on the spreader provides power to the beaters.
The hydraulic pump is two stage thereby supplying independent power to each beater motor.
A wide heavy duty belt covers the box floor. At the front of the spreader, this belt is attached to a sliding gate. At
the rear, this belt goes around a winged idler pulley and on the lower side is connected to a drive chain. At the
front of the spreader, this chain is driven by a hydraulic motor driving a planetary gear box and sprocket that is
powered by the tractor hydraulic system. See figure 1
page 19.
Driving the belt toward the rear of the spreader
pulls the
sliding gate rearward to move the load toward the beaters. A
remote flow control in the tractor cab or
a manually adjustable flow control in the drive chain
motor circuit regulates the speed the gate moves.
An end gate at the rear of the spreader is raised and lowered by two hydraulic cylinders, powered by the tractor
hydraulic system. See figure 5
page 17
. This gate must be lowered during loading to prevent packing of the material into
the beaters and to help prevent leakage during transport.
Page 12