Roto-Mix Roto-Spread 532-16, Руководство пользователя, инструкции по установке и каталог запчастей

Страница: 19 / 49

MAINTENANCE
PUT THE TRACTOR IN PARK, APPLY THE PARKING BRAKE, TURN OFF ENGINE AND
REMOVE IGNITION KEY BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS MA-
CHINE. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
READ THE FOLLOWING BEFORE
WELDING ON THIS MACHINE
1. When welding on your spreader, do not allow the
current to flow through the ball bearings or the
roller chains. Ground directly to the item being
welded.
2. The alternator shouwwld always be disconnected
if the spreader is not disconnected from the tow-
ing vehicle.
LUBRICATION
Bearings
Grease 2 lower beater bearings and 2 wing pulley
bearings every 100 hours of operation with 2 pumps of
grease. See figure 6.
PTO Drive
1. The PTO drive shaft yoke cross bearings must be
greased, both ends of assembly. Grease every 8
hrs of operation with one pump.
2. There is also a zerk at the center of the shaft
assembly to grease the telescoping shafts. It is
accessible through a slot in the guard. Grease
every 8 hrs of operation with 4 pumps.
Drive Chain Planetary Gearbox
(See figure 7)
Oil Specification:
M
obil Delvac Synthetic Gear Oil
75W-90 .
There is a check plug half way up on the gearbox.
Maintain the oil level to this check plug. Fill plug is lo-
cated on the top of the gearbox.
DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES BEFORE CLEANING, AD-
JUSTING, LUBRICATING, OR SERVICING THIS MACHINE.
Page 19
FIGURE 7. PLANETARY GEARBOX
FILL PLUG
ON TOP
CHECK
LEVEL PLUG
HYDRAULIC MOTOR PLANETARY GEARBOX
FIGURE 6. BEARING LUBRICATION
WINGED PULLEY
BEARING
(ONE EACH SIDE)
LOWER BEATER
BEARINGS
GREASE ZERKS