Rotenso ANERU Series, Руководство по обслуживанию

Страница: 316 / 552

 3. IDU Installation-Cassette 
4-6mm
Ceiling
Main body
Into the wind
Out of the wind
Panel foam 1
Panel foam 2
Outlet foam
Panel
Panel side sponge
Baffle
NOTE: If the height of the indoor unit needs to be
adjusted, you can do so through the openings at the
panel’s four corners. Make sure that the internal wiring
and drainpipe are not affected by this adjustment.
Water condensation
Failure to tighten screws can cause water leakage.
Loosen upper nut
1
2 Adjust lower nut
Gap not allowed
If the unit is not hung correctly and a gap exists, the unit’s
height must be adjusted to ensure proper function. The
unit’s height can be adjusted by loosening the upper nut,
and adjusting the lower nut.
3. Hang the intake grille on the panel, and then connect
the lead connectors of the louver motor and the control
box on the panel to the corresponding connectors of the
main body.
4. Re-installed into the style grid.
5.Reinstall the installation cover.
Fix the installation cover plate rope to the pillar of the
installation cover plate, and gently press the installation
cover plate into the panel.
Bolt
Install cover rope
Panel hook
When installing the
cover, slide the four
slide fasteners into
the corresponding
slots on the panel.
NOTE: After installation, the butt plugs of display, swing,
water pump and other wire bodies must be placed in the
electric control box.