Rotenso ANERU Series, Руководство по обслуживанию

Страница: 319 / 552

 3. IDU Installation-Duct 
3.6 Horizontal Installation
3.6.1 With External pump (9K, 12K models)
Cut both ends of the rubber hose into a straight one, use
it to connect the drain Connector A and the external
pump and safety it with clamps on both ends. Then
connect the drainpipe to the Connector B.
Connector A
Connector B
rubber hose
Clamps
Pump port
3.6.2 With External pump (18K model only)
Drain connector A, B & C are covered with caps originally.
Take the cap on drain connector B off, connect the
external pump to drain connector B using a hose & two
hoseclamps. Then connect the drainpipe to the connector
D.
Connector A
Connector B
Connector C
Connector D
Hose
Plug the external pump to the “PUMP” pin and the water
level sensor to the “CN5” to enable the pump.
Short connect the “CN5”
Unplug the “PUMP” pin
Remove the
cover
Fig. 1
3.6.3 With Built-in pump (24K, 36K, 48K models)
Drain connector A, B & C are covered with caps originally.
Connect the drainpipe to the connector D.
Connector A
Connector D
Connector B Connector C
3.7 Vertical Installation
3.7.1 No need pump (Disable pump)
The pump must be disabled while the unit is installed
vertically or the pump assembly is removed from its
original position.
Open the cover of E-Parts Box assembly, unplug the
“PUMP” pin to disable the pump function, and short
connect ”CN5” plug to disable the water level sensor. (see
Fig. 1)
3.7.2 Drain pipe connecting
When installed vertically (up flow), the pump must be
disabled firstly. Follow the 3.7.1 steps to disable the pump.
For the unit with external pump (9K ,12K &18K models),
the whole pump assembly can be removed. Then take the
cap on drain connector off and connect the drainpipe to
drain connector .
Connector