Communicator | 3.05
28
Square 1
Square 2
Address 2
OFF
ON
Address 3
ON
ON
6.1.3 Displaying the Controllers
•
Press
This screen displays all the controllers that are connected to the system.
- Represents a recognized controller
- No controller is recognized
NOTE:
The letter 'F' indicates that communication to that house has been lost. The 'F' continues to
appear until the unit is reset (disconnect and reconnect the power).
6.1.4 Listing the Network Devices
•
Go to
SYSTEM > Test > Network List.
•
PRIMARY FOUND
: Displays the number of primary units found in the network.
•
SECONDARY FOUND
: Displays the number of secondary units found in the network.
•
SCAN NETWORK?:
Use
+/-
key to select YES or NO and then press
ENTER
to scan the
network to find/remove primary or secondary units.
6.2 RS-232 Connection
The following sections detail how to set up an RS-232 connection between the Communicator and the
controllers.
•
Setting up the RS-232 Connection, page 29
•
RS-232 Approximate Distances and Baud Rate, page 30
0
01
16
17
32
33
48
49
64
01
16
NETWORK LIST
PRIMARY FOUND:
0
SECONDARY FOUND:
0
SCAN NETWORK?
NO
