7
www.roswellmarine.com
Wiring | Installation
2
1
Remove the safety lanyard by removing the two
bolts holding it onto the aluminum tweeter bridge
with a 3/32” Allen key.
Next wrap the lanyard around the location you
will be mounting your speaker. This is done by
wrapping the lanyard around the tower bar and
looping it though itself.
Strip 1/4” off of the wires and crimp the splice connectors
to the corresponding wires. Once attached use a heat gun
on the heat shrink to seal the connections.
NOTE: The illustrated Aviator tower is not pre wired for the
RGB controller.
Spea
ker Harness
Connectors
Tower Wires
Deutsch Connector
Installing Your Speaker
Two Person Job
Wire Strippers
Crimps
Heat Gun
H
ea
t shrink
Connect
ors
X12
Allen Key
3/32
