5
www.roswellmarine.com
Preparation
Preparation
Before you start make sure that you have all of the required tools to install your product.
Note: You will need to provide your own in boat and tower wiring unless your boat has
already been set up to the configurations you desire.
Roswell recommends using 16 gauge wire for the audio connections and 18 gauge wire for
the 12-volt LED connections.
12-Volt LED Wire (not included)
• Note: Consider how you would like to use the integrated RGB LED before you begin
installation. It can either be hard-wired to one of 7 different colors or you may purchase an
LED controller to allow any combination of colors and patterns (see next page for details).
• If you are hard-wiring the RGB LED’s on these speakers, you will need (1) 18 gauge power
and (1) 18 gauge ground wire from the speaker mounting locations to your power source.
• If you are using an RGB LED controller, you will need to run (1) 18 gauge power and (3) 18
gauge ground wires from the speaker mounting locations to your LED controller. Refer to
the RGB LED controller instructions for further information. Roswell RGB Controller (Part #.
C920-1620).
THREADLOCKER
3/8”
-16 x 0
.5
5/8”
-11 x 0
.5
5/8”
-11 x 1
3/8-
16”
x 0
.375
H
ea
t shrink
Connect
ors
X4
X2
X2
X8
X12
Wiring Harness
R1 Pro Speakers
Safety Lanyard
Wire Strippers
Crimps
Knife
Heat Gun
Red / Blue
Threadlock
Allen Key
3/16”
5/16”
3/32”
1.90” Insert
2.375” Insert
3.0” Insert
X2
X2
X2
X4
X4
X4
Package Contents
Tools Required
