8
www.roswellmarine.com
Installation
1.90” Insert
2.375” Insert
3.0” Insert
X4
X4
X4
2
3
4
Start by unscrewing the two clamp bolts and
the one set screw located at top of the clamp
using a 5/16” Allen key. Next open the clamp.
Once ready, select the correct size of insert
and place it in the clamp.
Have one person hold the
speaker in the desired location
close the clamp on the tower.
Then apply red threadlocker to
the two bolts and one set screw.
Using a 5/16” Allen key tighten
the bolts to secure the speaker.
Now that your speaker is in position loosen the four set
screws with a 3/16” Allen key. If your speaker is in the
correct position apply red thread locker to the four set
screws and tighten in position. If you need to adjust
the angle of the speaker, rotate it to the desired angle.
Apply red threadlocker to the four set screws and
tighten in the desired position.
Take the safety lanyard and
connect it to the tweeter bridge.
Apply a drop of blue threadlocker
to each bolt and tighten them
using a 3/32” Allen key.
Your speaker should look like
this after assembling. Make sure
that you still have access to the
Deutsch connector on the rear of
the housing.
THREADLOCKER
THREADLOCKER
THREADLOCKER
Red
Threadlock
Red
Threadlock
Blue
Threadlock
Allen Key
5/16
Allen Key
5/16”
Allen Key
3/16
Allen Key
3/32”
5/8”-11 x 0.5”
5/8”-11 x 1”
X2
X2
