Ross NK RCP-NKM, Руководство пользователя

Страница: 48 / 56

5–6 • Operating the RCP-NKM RCP-NKM User Guide (v3.0)
Clearing Protects Held by an RCP-NKM
A protect that is held by an RCP-NKM prevents the crosspoint being changed by another user. A protect can be sent
to the routing switcher from any connected remote control panel. Protects can be applied at any time, and are only
visible when the particular destination is selected.
To clear one protect from an RCP-NKM
1.
Press the destination key that has the protection applied.
The protection indicator is shown at the bottom left of the screen.
2. Press the protect key.
To clear all of the protects from an RCP-NKM
1. Open the RCP-NKM editor for the remote control panel that you want to clear (see “ Opening the RCP-NKM
Editor ” on page 4–1).
2. Select the Configuration tab.
3. Scroll to the Configuration frame.
4. If you want to clear all protects held by the RCP-NKM, select the Clear Protect(s) check box.
5. Send the current document (see “ Sending a Document to a Device ” on page 4–23).

Protects may be held by other remote control panels. Each remote control panel attached to a routing switcher
has to have its protects cleared separately.
Toggling Between Two Sources
If a CHOP key has been assigned to the RCP-NKM, you can use this key to toggle between two sources.
To toggle between two sources:
1. Press the key for the destination on which you want to receive the sources.
2. Press the key for the first source that you want to receive, followed by the TAKE key, if assigned.
3. Press the key for the second source that you want to receive, followed by the TAKE key, if assigned.
4. Do one of the following:
• Press CHOP once to toggle slowly between the two sources (toggle cadence is 1700 ms). The source label
on the screen toggles between the two sources. Slow chop is indicated by a lower-case c .