Ross NK RCP-NKM, Руководство пользователя

Страница: 31 / 56

RCP-NKM User Guide (v3.0) Setting Up the RCP-NKM • 4–13
4.
Send the current document to the device by clicking
Send Configuration
located on the lower Device
Configuration window (see “ Sending a Document to a Device ” on page 4–23).
Assigning a Macro to a Key
If you want to perform several tasks at the press of a key, assign a macro key to the RCP-NKM, then record a macro
using this key. For more information see “
Recording a Macro Using the Panel ” on page 4–13. You can assign up
to 40 macros to an RCP-NKM.
To assign a macro to a key
1.
Open the RCP-NKM editor (see “ Opening the RCP-NKM Editor ” on page 4–1).
2.
On the simulated RCP-NKM, select the key that you want to use for the macro.
3.
In the pop-up dialog:
a.
Select Macro as the key type.
b.
Select the Macro Name as the key value.
The simulated RCP-NKM in DashBoard shows the macro number on the selected key, for example, Macro 1 .
4.
Send the current document to the device by clicking
Send Configuration
located on the lower Device
Configuration window (see “ Sending a Document to a Device ” on page 4–23).
Recording a Macro Using the Panel
Macros can be recorded using the keys on the RCP-NKM. You may record up to 112 key presses in a macro. A
macro key must be assigned on the RCP-NKM before you can use it to record the macro.
To record a macro using the panel
1.
On the RCP-NKM, hold the Macro < n > key until the LCD shows MACRO RECORD and the key
illuminates.
2.
Release the key.
The key flashes slowly, indicating that the RCP-NKM is now ready to record a macro.
3.
Press the required keys in the correct sequence until your task is completed.
Each key acknowledges that it has been pressed by flashing briefly.
4. Press the Macro < n > key again to end the recording process.
The macro is recorded.

If you unassign the Macro < n > key from the macro function, the recorded macro is held in memory. You can
re-assign the macro to a key using the same macro number under which the macro was recorded.
Adding to a Macro Using the Panel
You can add extra key sequences to an existing macro. You can join two existing macros together.
To add to a macro using the panel
1.
On the RCP-NKM, hold the Macro < n > key until the key begins to flash rapidly, then release the key.
The key flashes slowly, indicating that the RCP-NKM is now ready to record a macro.
2.
Hold the Macro < n > key again.
The selected macro is played back internally, ready to receive the additional key sequences.
3.
Do one of the following:
• To add an extra key sequence, press the required keys in the correct sequence until your task is completed.
• To add an existing macro, press the key for that macro.