Ross NK RCP-NKM, Руководство пользователя

Страница: 33 / 56

RCP-NKM User Guide (v3.0) Setting Up the RCP-NKM • 4–15
To assign a protect key
1. Open the RCP-NKM editor (see “ Opening the RCP-NKM Editor ” on page 4–1).
2. On the simulated RCP-NKM, select the key that you want to use for the protect key.
3. In the pop-up dialog:
a. Select Function as the key type.
b. Select Protect as the key value.
The simulated RCP-NKM in DashBoard shows PROT on the selected key.
4. Select the Configuration tab.
5. Scroll to the Configuration frame.
6. Select the mode of protection that you want for the protect key. Use the information in Table 4.5 as a guide..
7. Send the current document to the device by clicking
Send Configuration
located on the lower Device
Configuration window (see “ Sending a Document to a Device ” on page 4–23).
Assigning a TAKE Key
If you want to pre-load a switch sequence, but delay the switch, assign a TAKE key on the menu. If a TAKE key is
assigned, then all switches on that menu are activated by pressing the TAKE key instead of the
source/crosspoint/macro key. You should assign a TAKE key on each menu that requires this switching type.
To assign a TAKE key
1. Open the RCP-NKM editor (see “ Opening the RCP-NKM Editor ” on page 4–1).
2. On the simulated RCP-NKM, select the key that you want to use for the TAKE key.
3. In the pop-up dialog:
a. Select Function as the key type.
b. Select Take .
The simulated RCP-NKM in DashBoard shows TAKE on the selected key.
4. Send the current document to the device by clicking
Send Configuration
located on the lower Device
Configuration window (see “ Sending a Document to a Device ” on page 4–23).
Assigning a CHOP Key
If you want to toggle two different sources to the same destination, assign a CHOP key to the RCP-NKM. For
example, the destination may be the monitor that you are viewing, and the sources may be feeds from two different
camera locations. When you use the
CHOP key, the toggle rate can be slow or fast (see “ Toggling Between Two
Sources ” on page 5–6).
Table 4.5 Protection Descriptions
Protect Mode Description
Block Other Panels The protected destination and level(s) cannot be switched to another source
by other remote control panels.
The protected destination and level(s)
can be switched to another source on
the current remote control panel.
Block All Panels The protected destination and level(s) cannot be switched to another source
by the current remote control panel or other remote control panels.