Automatic Escalator Deep Cleaning Machine – Rotomac 360
Created by Rosemor International Ltd
Page 20
4 Maintenance / Care
4.1 Safety measures during cleaning and
maintenance of the machine
•
Before any maintenance or cleaning
work is carried out, the machine must be
separated from the mains with the main
switch being set to "0“ and the mains
plug disconnected. This will prevent
accidents caused by electrical voltage or
moving parts.
•
During cleaning or maintenance work on
the machine, when parts are being
replaced or new equipment fitted for a
new function, care must be taken that
the machine can not accidentally start,
roll or turn over and that no parts can fall
down or flap closed.
If the operator has any questions or doubts
regarding safety, he must request advice from
the manufacturer or the relevant sales agent
before starting the machine.
4.2 Daily care
•
Examine the power cable for any
damage.
•
Always empty the dirty-water tank (2)
following use and rinse thoroughly with
water (Note instructions in Section
3.14).
•
Inspect brushes (24) (Note instructions
in Section 3.2) and clean.
•
Rinse out suction basin (21).
•
Clean stripping brush (23).
4.3 Weekly care
•
Clean and lightly lubricate the extended
lifting spindles (18).
•
Check suction tubes for leaks.
•
Check seal strips (22) and renew if
necessary (Fig. 22:).
Fig. 22: Suction basin / seal strip
4.4 Maintenance after 30 service hours
•
Remove suction basin (21) and stripping
brush (23) and rinse (Fig. 22:)
•
Check chains (34) for correct tension
and, if necessary, tighten with chain
adjuster 36) (see Section 4.6.1
Tightening the chain and Fig. 24:)
•
Clean chains (34) and treat with a chain
spray (15)
•
Check spray nozzles (37) and clean if
necessary
•
Check glide rails (28) on the right and
the left. Replace if showing signs of
wear (Fig.22:)
•
Check sliding elements of the step
adjustment device (16 and 19). Replace
in case of wear
•
Check seal strip (22) and renew if
necessary (Fig. 22:)
Maintenance work may be
carried out by trained
personnel only.