8. Timer Control:
Treatment time of TENS can be preset with Timer Control. This switch has 3
positions - 15, 30 and C (Continuous). Push the Timer Control until engaged in
position desired.
9. Check/Replace the Battery:
Over time, in order to ensure the functional safety of TENS, changing the
battery is necessary.
1. Make sure that both intensity controls
are switched to off position.
2. Slide the battery compartment cover and
remove.
3. Remove the battery from the
compartment.
4. Insert the battery into the compartment.
Note the polarity indicated on the battery
and in the compartment.
5. Replace the battery compartment cover
and slide to close.
Chapter 18: BATTERY INFORMATION
TENS 3000 can be used with a rechargeable battery
when necessary. If you use rechargeable batteries, please follow
the instructions.
5. Mode Control:
Expose the controls by sliding front cover down from top of unit.
This switch has 3 positions; B for Burst stimulation, N for Constant
Stimulation, and M for modulation stimulation. Push the Mode Selector
until engaged in position desired.
6. Pulse Rate Control:
This dial determines how many electrical impulses are applied
through the skin each second. By turning these controls, the number
of current impulses per second (Hz) for both channels can be
continually adjusted. Unless otherwise instructed, turn the pulse rate
7. Pulse Width Control:
This dial adjusts the length of time each electrical signal is applied
through the skin, which controls the strength and sensation of the
stimulation. If no instructions regarding the pulse width are given in
therapy, set the control to the suggested 70-120 µs.
16
17
