Page 19
6.17 Mounting the safety strip under the worktop
*
Option: Ropox always recommends the use of safety strips for electrically operated
frames.
Be careful not to bend or damage the safety strip during transport or mounting.
Be careful when mounting the safety strip, bending or twisting can reflect on the
performance of the safety strip.
The surface to which the safety strip is to be attached must be clean, dry and
degreased to obtain optimum adhesion.
Please refer to safety strip mounting guide
6.17.1 Mount the safety strip on the bottom side of the wooden front fascia by means of the
double-adhesive tape.
Remove the protective paper of the tape and press on the safety strip. Be aware of
minimum bending radius (2 cm inside)
6.17.2 Pull out the red short circuit plug (E) of the short cable (A) (marked with red).
Connect the plug at the end of the safety strip (D) in the available short cable (A) (marked
with red).
Insert the male plug of the extension cord into the first safety stop (right side of the frame).
In the case of more safety stops, connect them in series and end the series by inserting the
remaining short-circuit plug into the available male plug of the last safety stop.
6.18 Mounting the press pad for disabled persons
*
Option
*
If the frame is manually operated, this item does not apply.
6.18.1 The press pad for height adjustment must be placed in the wooden front fascia
.
It consists
of a press pad contact and a 150 cm long cable provided with a DIN-plug.
The press pad and the cable are delivered as one unit ready for mounting.
Drill holes as illustrated to suit the required position.
6.18.2 Fit the press pad by pulling the cable through the large hole and fasten it in the small holes
by means of the M6 nuts provided.
6.18.3 After fitting the press pad, fasten the cable under the worktop with cable bearers so that it does
not sag. Finally fit the DIN-plug in the control unit.
6.19 Mounting of distance plates (1cm) for skirting board
*
Option
6.19.1 In case of skirting boards, you can use the 1 cm deep distance plate to pack the frame out
from the wall.
