Page 17
6.12 Mounting the concealment panels
*
Option: Fittings for mounting the concealment panels (panels not supplied by Ropox)
For three-legged frames use two sets of fittings.
6.12.1 Inside/lower concealment panels:
Fasten the Z-fittings to the wall in the middle between the legs. Fit Velcro on the Z-fittings
and the concealment panels.
Also fit Velcro on the legs and the concealment panels. The concealment panels may now
be fitted.
Outside/upper cover plate:
Fit the two angular fittings on the inside of the outside/upper concealment panel. Now fit the
angular fittings on the bottom side of the worktop.
6.12.2 Dimension sketch outside/upper concealment panel. The length is identical with the length
of the worktop. The height must be 45 cm.
6.12.3 Dimension sketch inside/lower concealment panel. The length is identical with the length of
the worktop. The height must be 40 cm.
6.12.4 Inside/lower concealment panel (in case of supporting feet). The length is identical with the
length of the worktop. The height must be 40 cm. Cut-out for feet must be 8 cm wide and 3
cm high. The cut-outs of the cover plate must suit the position of the supporting feet.
6.13 Conversion from a manual to a electric version
*
Option
6.13.1 Cut the spindle into two parts.
Loosen the stop rings on each side of the spindles. Then push the spindles away from each
other.
6.13.2 Remove the bolts for fastening the transmission, and remove the transmission from the
spindle.
6.13.3 For worktop length 60-104 cm one motor is mounted. For mounting of motors return to 6.13
Together with the mounting bracket there is a nut, which fits into the grove at the bottom edge
of the aluminium profile. When you start tightening the bolt, the nut will turn and interlock in the
groove.
6.13.4 For worktop length 105-300 cm two motors are mounted. For mounting of motors return to
6.13.
Together with the mounting bracket there is a nut, which fits into the grove at the bottom edge
of the aluminium profile. When you start tightening the bolt, the nut will turn and interlock in the
groove.
6.13.5 Slide the connecting bush onto the spindle, and push the two spindle parts together inside the
connection. Fasten the four bolts.
