Page 14
6. Mounting instructions, descriptions
Prior to assembly check that all parts have been provided. See list of components, from
page 21. See also mounting drawings from page 7.
6.1 Assembly of frame
6.1.1 Place the aluminium profile on the floor.
*
If supporting feet have been ordered, first see mounting of feet, item 6.15.
6.1.2 Insert the transmission with fasteners into the groove of the aluminium profile and pass the
spindle through the transmission (do not secure).
6.1.3 Fit a stop ring and a washer on the spindle on either side of the transmission (do not
secure). The washer should be at the end.
6.1.4 Push the legs into the groove of the lower side of the aluminium profile, one leg from either
side.
6.1.5 Position the adjustable legs on the aluminium profile.
If there are any socket outlets obstructing the legs, move the leg a little towards the middle.
For frames with two legs, place one leg on either side. For frames with three legs, place the
third leg at the middle of the aluminium profile.
Secure each leg to the aluminium profile with two bolts.
To obtain the correct height (65-95 cm without worktop) simply mount and adjust the
threaded bolt to each leg according to fig. 6.3.2.
Note: If the sink or hotplate is placed at the middle of the worktop, move the third leg if any,
to the right or left to ensure that the leg and support arm are fitted in the immediate vicinity
of the sink, hotplate etc.
6.2 Mounting the support arms on the frame
Note: Prior to mounting of the support arms it is important to know the location of the sink
and hotplate in relation to the support arms and the handle rod.
Where you have an adjustable leg always position a support arm directly over it. Do not
adjust the tilting of the arm supports that are positioned on top of the legs (see 6.8).
Position the transmission box for the winding handle spindle at the required position before
mounting the support arms from either side.
6.2.1 The support arms may be pushed into the aluminium profile from either side to the required
position and fastened with two screws on each support.
We recommend a maximum distance between the support arms of 60 cm in order to obtain
optimum stability.
6.2.2 To prevent the spindle from working its way out of the frame during use, push the two stop
rings and spacers of the spindle towards each leg and fasten.
The equipment should always be assembled by competent personnel.
