Page 15
6.3 Mounting the frame on the wall
6.3.1 Place the frame against the wall and align it. Adjust the two threaded bolts under the legs to
ensure that the frame is horizontal.
6.3.2 To obtain the correct height (65-95 cm without worktop) adjust the threaded bolt to each
leg. After mounting, the threaded bolts can be removed.
Mark and drill the holes for fastening.
Fasten the frame to the wall by means of screws and raw plugs suiting the material of the
wall.
6.3.3 Misalignments up to 0,45 cm on the wall may be adjusted by fitting the provided spacers
(0,15 cm) between the legs and the wall.
Loosen the legs a bit and slide the spacers in between the wall and the legs, as required, at
the top or bottom depending on whether the wall is vertical.
6.4 Mounting of fittings for front fascia
6.4.1 Fittings for mounting of the wooden front fascia are provided, corresponding to the number
of support arms. Place the front fascia fittings on the side of the support arm and fasten
them loosely by means of the screw provided.
6.4.2 On the outermost support arms we recommend pointing the front fascia fittings towards the
middle of the frame to prevent them from conflicting with the side fascia.
6.5 Mounting the worktop
6.5.1
Place the tabletop on the frame. The maximum permissible distance from the back of the
tabletop to the wall is 0.5 cm. (safety issue)
If the frame is moved away from the wall, the distance from the back of tabletop to the wall
MUST still be equal to or less than 0.5 cm.
6.5.2 The standard aluminium profile is 5 cm shorter than the worktop, resulting in a 2.5 cm
projection on either side.
6.5.3 Fasten the worktop with screws through the holes of the support arms.
6.6 Mounting the wooden front fascia
6.6.1 Fasten the wooden front fascia at the required position under the worktop by means of a
clamp. Press the front fascia fittings forward against the wooden front fascia and fasten with
screws from the inside.
6.6.2 By screwing the front fascia fittings into the worktop you pull the front fascia upward.
Finally tighten the screws on the side of the support arm.
6.7 Mounting the side fascia
6.7.1 Furniture fittings are provided with the frame to keep the wooden side fascia up against the
worktop.
