Startup and operation
Version 1
RES-430
Page 21
9.1.3
Rear view of the terminal
9.2
General controller configuration
The possible controller configurations are explained in the following sections. Proceed as described in
section 9.7.1 "Initial startup" on page 36 to start up the controller for the first time.
The menu step numbers indicated in the following are valid as of software revision 007. Please refer
to the reference table in section 10.4 "Menu structure" on page 42 for information about the num-
bers used for older controller versions.
9.2.1
Setting the language
The menu language can be changed on the controller without interrupting operation. It is set with step 201 in the
Configuration menu:
The following settings are possible:
English, German, Italian
As of software revision 100 also:
French, Spanish, Dutch, Danish, Finnish, Swedish, Greek, Turkish, Portugese
The language which is selected in this menu remains set even if the factory settings are restored
(step 202 in the Configuration menu).
9.2.2
Restoring the factory settings
The internal controller settings can be reset to the factory settings with step 202 in the Configuration menu. Only
the language setting (step 201 in the Configuration menu) remains unchanged.
Please refer to section 11 "Factory settings" on page 64 for more information about the factory settings.
If the controller settings are unknown when it is started up for the first time, the factory settings
must be restored in order to prevent malfunctions.
9.2.3
Configuration of the alloy (temperature coefficient)
The heatsealing band alloy and the corresponding temperature coefficient are set with steps 203 and 204 in the
Configuration menu:
Nameplate
Mounting clamps
Connecting cables
Mounting clamps
!
!
!
