Roni LIFT-O-FLEX 19000 Series, Руководство пользователя

Страница: 10 / 25

RonI, INC

8001 Tower Point Drive

Charlotte, NC 28227

U.S.A.

Toll Free (866) 543-8635
Ph.: (704) 847-2464

Fax: (704) 847-6739

Email: info@roni.com

Web Site: http://www.liftoflex.com
Rev July 2016
10
8 Instruction
Use the lifter properly in order to avoid work injuries from lifting.
8.1 Charging
The lifter is to be charged every night, over weekend, holidays and longer periods when not in use or the
batteries will go dead. In this way you are ensured a fully charged lifter at all times.
Attention! If you do not charge the batteries after each duration of use, the batteries can be harmed.
It is not possible to overload them.

Always charge in a dry area.

Disconnect lift motor power cable from Electronic Power Pack

Connect charger to Electronic Power Pack. Lamps on charger will not light up.

Connect the charger to wall outlet. A red and yellow lamp will go on when charging.
Attention! Do not operate the device while charging.

A green lamp will go on when charging is complete.

The yellow lamp flashes when the battery is 80% charged, battery now is on trickle charge.

Disconnect charger from wall outlet.

Disconnect charger from Electronic Power Pack.
Red lamp = 110 volt voltage is connected.
Green lamp = Charged and maintenance charging to keep level high.
Note: Steps to follow to eliminate potential sparking when connecting charger to Electronic Power
Pack:

Disconnect lift motor power cable from Electronic Power Pack.

Discharge Electronic Power Pack capacitor by engaging the “Up/Down” pushbutton on the remote
controller.

Connect charger to Electronic Power Pack.

Connect charger to wall outlet.
Attention! Charger is not to be exposed to water.
Note: 19139B Electronic Power Pack voltmeter must be switched on during lifter operation.