RonI, INC
8001 Tower Point Drive
Charlotte, NC 28227
U.S.A.
Toll Free (866) 543-8635
Ph.: (704) 847-2464
Fax: (704) 847-6739
Email:
Web Site: http://www.liftoflex.com
Rev July 2016
8
7
Should you have an accessory on the lifter that requires DC power this can be connected to the power
pack (5 next page) into the same outlet as the battery charger. While charging, these accessories will have
to be disconnected.
After charged – remember to reconnect the plug for the accessory.
5.3 Assembling the Electronic Power Pack, Handlebar and Remote Contro
l
Modules: 1 piece upper lock (5), 1 piece power pack (12), 1 piece grip (13), and 1 piece remote control
1
Guide the upper lock nut of the power pack into (5) the tracks of the back of the mast, the knob shall be
on top (slightly off center)
2
Lift the power pack (12) by lifting the upper lock (5); slide the power pack (12) so its lower fastening
hook fastens at the bottom of the mast. Lower the upper connector (5) until it covers the top of the power
pack mounting detent and tighten.
3
Plug in the connector to the front of the power pack. Cable with plug to motor (black connector with red
handle).
4
Insert the handle slides into the two slots in the back of the lift mast and slide down the handle and secure
at the desired height.
5
Connect the remote control device to the power pack (12). The plug shall be on the right front side (the
same side as the plug for the motor).
6
The lifter is now ready for use.
