Rohde & Schwarz R&S RTB2000, Руководство пользователя

Страница: 302 / 609

Remote control commands
R&S
®
RTB2000
302 User Manual 1333.1611.02 ─ 11
15 Remote control commands
This chapter provides the description of all remote commands available for
R&S
RTB2000. The commands are sorted according to the menu structure of the
instrument. A list of commands in alphabetical order ist given in the "List of Com-
mands" at the end of this documentation.
Processing of remote control commands
The response time on remote commands depends on several factors:
●
Number of active channels
●
Number of active measurements
●
Size of the acquisition memory
●
Timebase
●
Trigger frequency
The R&S RTB2000 processes measurement queries in the following way:
●
In stop mode or with slow trigger frequency if no new data since last value calcula-
tion is available, the oscilloscope sends the measured value in the response.
●
Otherwise, if new data since last value calculation is available, the oscilloscope cal-
culates and sends the response.
● Conventions used in command description .......................................................... 302
● Programming examples ........................................................................................ 303
● Common commands .............................................................................................309
● Waveform setup .................................................................................................... 312
● Trigger ...................................................................................................................330
● Waveform analysis ................................................................................................345
● Measurements ...................................................................................................... 381
● Applications ...........................................................................................................400
● Documenting results ............................................................................................. 427
● General instrument setup ......................................................................................449
● Serial bus analysis ................................................................................................ 463
● Mixed signal option (option R&S RTB-B1) ............................................................ 529
● Signal generation (option R&S RTB-B6) ...............................................................541
● Status reporting .....................................................................................................558
15.1 Conventions used in command description
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
Conventions used in command description