Installation and Operation
39
User Manual (Hardware) | 2904.4460.02 - 04
Connecting to Power
CLIPSTER
Connecting to Power
For safety information, see "Connecting to Power" on page 9.
Perform the following steps:
1.
Plug the AC power cable into the AC power connector on the rear panel
of the product. Only use the AC power cable delivered with the product.
2.
Plug the AC power cable into a power outlet with ground contact. The
required ratings are listed in the data sheet.
3.
If necessary, also ground the product using the grounding terminal.
4.
Install any other remaining cables before switching on the product.
Operating the System
This chapter describes how to operate the CLIPSTER
hardware, i.e. it is
explained how to start the system and how to shut it down. For both proce-
dures you have to use the power switch of the operation items at the front of
the system.
The following topics are covered:
●
●
●
Shutting Down the System (page 41)
●
Starting the System
After a proper installation of the system you may start the R&S system at
any time.
Perform the following steps:
•
Press the power switch to turn on the system.
The system will be started. As with any standard computer after initial
booting, the system begins to load the installed operating system.
When the operating system has finished its loading, you can begin to
work with the R&S system right away.
Содержание CLIPSTER 6 Mk2
Страница 1: ...R S CLIPSTER Mk2 Mastering Station User Manual Hardware Version 04 2904 4460 02...
Страница 16: ...Safety and Regulatory Information FC Declaration of Conformity CLIPSTER 16 User Manual Hardware 2904 4460 02 04...
Страница 76: ...Appendix Packing Instructions CLIPSTER 76 User Manual Hardware 2904 4460 02 04...
