Rohde & Schwarz CLIPSTER 6 Mk2, Руководство пользователя

Страница: 9 / 78

Safety and Regulatory Information
9
User Manual (Hardware) | 2904.4460.02 - 04
Safety Instructions
CLIPSTER
Choosing the Operating Site
Only use the product indoors. The product casing is not waterproof. Water
that enters can electrically connect the casing with live parts, which can lead
to electric shock, serious personal injury or death if you touch the casing. If
Rohde & Schwarz provides a carrying bag designed for your product, you
can use the product outdoors.
Unless otherwise specified, you can operate the product up to an altitude of
2000 m above sea level. The product is suitable for pollution degree 2 envi-
ronments where nonconductive contamination can occur. This equipment is
to be installed for operation in an environment with ambient temperature
below 35ºC (95ºF), and humidity 5 - 95%.
The system is to be operated only when mounted and mechanically secured
into a 19-inch wide rack.
Setting Up the Product
Always place the product on a stable, flat and level surface with the bottom
of the product facing down. If the product is designed for different positions,
secure the product so that it cannot fall over.
If stacking is possible, keep in mind that a stack of products can fall over and
cause injury.
If you mount products in a rack, ensure that the rack has sufficient load
capacity and stability. Observe the specifications of the rack manufacturer.
Always install the products from the bottom shelf to the top shelf so that the
rack stands securely. Secure the product so that it cannot fall off the rack.
Unplug the system before you move it or if you think it has become damaged
in any way.
Connecting to Power
The product is an overvoltage category II product and has to be connected
to a fixed installation used to supply energy-consuming equipment such as
household appliances and similar loads. Be aware that electrically powered
products have risks, such as electric shock, fire, personal injury or even
death.
Maintenance inside the system should only be performed by personnel quali-
fied for handling and testing electrical equipment. Exercise utmost care when
performing any kind of work inside the system while it is on.
Take the following measures for your safety:
●
The enclosure must only be operated from a power supply input voltage
range of 100-127 VAC and 200-240 VAC, frequency is 50 to 60 Hz.